MTD 760 Operator's Manual page 21

S,, y ,-
brakeis in need of adjustment.Thebrakedisc can be
foundon the rightsideof the transmissionin the rearof
the tractor.Adjustif necessaryas follows:
1. Lookingat thetransmissionfrom the rightside of the
tractor,locatethe compression springand brakedisc•
See Figure16.
2. Loosen,but do NOTremove,the hex nutfoundon the
rightsideof the brakeassembly• See Figure16.
3. Usinga feelergauge,set the gap betweenthe brake
disc and the brakepuck at .011".
4. Re-tightenthe hexnut loosenedearlier•
Seat Adjustment
_1= ARNING: Before operating this
machine, make sure the seat is
engaged in the seat stop, stand
behind the machine and pull back
on seat until fully engaged into
stop.
Standard Seat
Toadjust the positionof the seat,loosenthe two hex
screwson the bottomof the seat.Slide the seatforward
or backwardas desired.Retightenthe two screws.See
Figure17.
Knob Adjustment Seat (if so equipped)
Toadjust the positionof the seaton modelsso equipped,
loosenthe two knobs on the bottomof the seat. See
Figure18. Slidethe seat forwardor backwardas desired.
Retightenthe two knobs.
Quick Adjust Seat (if so equipped)
Toadjust the positionof the seaton modelsequipped
with a seat adjustmentlever,movetheseat adjustment
lever(locatedunder theseat) to the left and slidethe seat
forwardor rearward.See Figure19.Makesureseat is
locked intopositionbeforeoperatingthe tractor•
Set gap .011"
Figure 16
Hex Nut
f
Figure 17
,,J
WARNING
Before operating this
machine, make sure
the seat is engaged in
the seat stop, stand
behind the machine
and pull back on seat
until fully engaged into
stop.
Figure 19 Figure 18
21