MTD 760 Operator's Manual page 10

Your Lawn
Tractor
f _, Attaching The Seat
Seatstyles vary bytractormodeland thereare three
--_ _ differentstyles available.
,---_-h _ • StandardAdjustment
QuickAdjustment&
E
__d_'l'tlllntll ||1_ ,' KnobAdjustment
"" If theseat for yourtractordid notcome attached,referto
Figure4, Figure5, and Figure6 to identifyyourtractor's
seat styleand followthe applicableinstructionsbelowto
attachit.
WARNING
Before operating this
machine, make sure
theseat s engaged n
the seat stop stand
behind the machine
and pu back on seat
until fully engaged
into Stopl
J
Figure 4
/ i
NOTE Forsh pp ng rea-
sons, seats are e_ther
fastened to the tractor
seat s p vot bracket w th
a plastic tMe, or mounted
backward tothe pwot
bracket.In either case,
free the seat form ts
NOTE:Forshippingreasons,seatsare eitherfastened
to the tractorseat'spivot bracketwith a plastictie, or
mountedbackwardto the pivotbracket.In eithercase,
freethe seat form its shippingpositionand removethe
two hex screws(or knobs,on modelsso equipped)from
the bottomof seat beforeproceedingwith applicable
instructionsbelow.
Standard Adjustment Seat
1. Positionthe shoulderscrews (foundon the baseof the
seat) insidethe slot openingsin the seat pivotbracket.
Figure4.
2. Slide theseat slightlyrearwardin the seat pivot
bracket,lining up the rear slots in the pivot bracket
with the remainingtwo holesin the seat'sbase.
3. Selectdesiredpositionforthe seat,and securewith
the two hexscrewsremovedearlier.SeeFigure4.
Quick Adjustment Seat
NOTE:If yourseat wasshippedmountedbackwardson
the seatpivot bracket,pull outthe tab foundon the seat
stop and hold it open whileslidingthe seat off the seat
pivotbracket.See Figure5.
Figure 5
1. Line up the plasticseatspacerswith the slotsin seat
pivotbracket.
2. Slide seat in until frontseat spacerengagesthe seat
stop.See Figure5.
_IL ARNING: Before operating this
machine, make sure the seat is
engaged in the seat stop, stand
behind the machine and pull back
shipping position and on seat until fully engaged into
removethe two hex stop.
screws (or knobs, on
Knob Adjustment Seat
models so equipped)
1. Positionthe shoulderscrews (foundon the baseof the
from the bottom of seat
seat) insidethe slot openingsin the seat pivotbracket.
Figure6
before proceed!ngw!th ............... .
annlicable instructions
........... 2. Slide theseat slightlyrearwardin the seat pivot
FF ' ..... ....
........ bracket lining up the rear slots in the pivotbracket
_.. _ .... ,
w th the reman ng two hoes n the seats base
Figure 6
3. Selectdesiredpositionforthe seat,and securewith
_ the two knobs removed earlier.See Figure6.
10