Controls And Features; Cutting Height Adjustment Lever - MTD 11A-030F200 Operator's Manual

Controls a nd Features
4
Recoil Starter
Cutting Height
Adjustment
Lever (One at
each wheel)
\
\
J
Figure 4-1
BladeControl
The blade control is attached to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the
unit. Release it to stop engine and blade.
_ ARNING: This blade control is a safety device.
Never attempt to bypass its operations.
Cutting HeightAdjustmentLever
One adjustment lever is located on each wheel and is used to
adjust the cutting height. All four levers have to be at the same
relative position to ensure a uniform cut. To adjust the cutting
height, refer to the "Assembly & Set-Up" Section.
RecoilStarter
The recoil starter is attached to the right upper handle. Stand
behind the unit and pull the recoil starter rope to start the unit.
13