Controls & Features - MTD Series 400 Operator's Manual

Controls and Features
Bail Drive
Control †
Recoil Starter
Grass Catcher
† If Equipped
Bail Blade Control
The bail blade control is attached to the upper handle of the
mower. Depress and squeeze it against the upper handle to
operate the unit. Release it to stop engine and blade.
WARNING:
This bail blade control is a safety
device. Never attempt to bypass its operations.
Bail Drive Control
(If Equipped)
The bail drive control is located on the underside of the upper
handle and is used to engage the drive. Squeeze it against the
upper handle to engage the drive; release it to stop mower from
propelling.
Cutting Height Adjustment Lever
The adjustment lever is located on the right rear wheel. To
adjust the cutting height, refer to the "Assembly & Set Up"
Section.
Bail Blade Control
Throttle Control
Cutting Height
Adjustment Lever
Figure 4-1
Grass Catcher
The grass catcher, located at the rear of the mower, is used to bag
the grass clippings for disposal at another site. Once the bag is
f ull, remove it using the handle provided and empty it before any
further mowing.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand
behind the unit and pull the recoil starter rope to start the unit.
Throttle Control
Throttle Control is located on the left upper handle. Throttle
Control maked for "Stop","Start" and "Run" positions. Refer to
the "Operation" Section.
4
11