Chassis Intrusion Switch - Dell OptiPlex GX200 Service Manual

To remove the control panel, perform the following steps:
1. Disconnect the control panel cable from the control panel connector on the system board (see
PANEL connector).
Note the routing of the control panel cable as you remove it from the chassis.
2. Disconnect the the chassis intrusion switch cable connector from the control panel.
3. Remove the mounting screw that secures the control panel to the chassis.
4. Remove the control panel cable.
5. Pull the control panel cable through the opening in the front wall, and carefully remove the cable from the routing tab in the chassis.
6. Pull out on the control panel to detach it from the chassis.
Note the routing of the control panel cable as you remove it from the chassis.

Chassis Intrusion Switch

Figure 9. Chassis Intrusion Switch Removal
To remove the chassis intrusion switch, perform the following steps:
1 Control panel
2 Control panel connector
3 Chassis intrusion cable connector
4 Chassis intrusion switch
1 Control panel
2 Control panel cable connector
3 Chassis intrusion cable connector
4 Chassis intrusion switch
"System Board Labels" for the location of the