Chassis Intrusion Switch - Dell OptiPlex GX1 Service Manual

Removing and Replacing Parts: Dell OptiPlex GX1 Systems Service Manual
When you install the replacement control panel, be sure to put the right side of the control panel behind the
mounting tab.

Chassis Intrusion Switch

Figure 7. Chassis Intrusion Switch Removal
To remove the chassis intrusion switch, perform the following steps:
1. Remove the drive
2. Remove the power
3. Remove the control
4. Disconnect the chassis intrusion switch cable connector from the control panel.
Note the routing of the chassis intrusion cable as you remove the cable from the chassis. Chassis
hooks may hold the cable in place inside the chassis.
5. Slide the chassis intrusion switch out of its slot and remove the switch and its attached cable from the
chassis.
6. Install the replacement chassis intrusion switch and cable.
7. To reset the chassis intrusion detector, enter the System Setup program and reset Chassis Intrusion
to Not Detected (see your online System User's Guide for instructions).
Drives
file:///C|/infodev/2013/eDoc/OpGX1/SM/remsff.htm[2/21/2013 11:45:32 AM]
shelf.
supply.
panel.
1 Control panel
2 Chassis intrusion
switch