Controls And Features - MTD A00 Series Operator's Manual

Controls a nd Features
4
Control
Cutting Height
Side Discharge Adjustment
Chute Lever
"Model 11A-A24T055 Shown
Mulch Plug
Cutting Height
Adjustment
Lever
Figure 4-1
J
8lade Control
The blade control is attached to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the
unit. Release it to stop engine and blade.
_ ARNING: This blade control is a safety device.
Never attempt to bypass its operations.
Cutting HeightAdjustmentLever
One adjustment lever is located on the right rear wheel and one
is located on the right front wheel. Both levers have to be at the
same relative position to ensure a uniform cut. To adjust the
cutting height, refer to the "Assembly & Set-Up" Section.
GrassCatcher(If Equipped)
The grass catcher, located at the rear of the mower, is used to bag
the grass clippings for disposal at another site. Once the bag is
full, remove it up through the handles using the strap provided
and empty it before any further mowing.
MulchPlug(if Equipped)
The mulch plug is used for mulching purposes. Instead of
collecting the grass clippings in a grass catcher or using the
side discharge chute, some mower models have the option
of recirculating the clippings back to the lawn. This is called
mulching.
SideDischargeChute(if Equipped)
Your mower may be shipped as a mulcher. To discharge the
grass clippings to the side instead, follow the instructions in the
"Assembly & Set-Up" section to attach the side discharge chute.
_lb ARNING:
Keep hands and feet away from the
chute area on cutting deck. Refer to warning label
on the unit.
RecoilStarter
The recoil starter is attached to the right upper handle. Stand
behind the unit and pull the recoil starter rope to start the unit.
13