Table of Contents
Advertisement
Specific Symptoms
Screen image is too small
Image is centered on screen,
but does not fill entire viewing
area
Cannot adjust the monitor with
OSD does not appear on the
the buttons on the front panel
screen
No Input Signal when user
No picture, the LED light is
controls are pressed
blue. When press "up", "down"
or "Menu" key, the message "
No input signal " will appear.
The picture does not fill the
The picture cannot fill the
entire screen.
height or width of the screen
Back to Contents Page
What You Experience
Reset the monitor to Factory Settings.
l
Turn off the monitor, unplug the power cord, plug back, and then turn on the monitor.
l
Check the signal source. Ensure the Computer is not in the power saving mode by
l
moving the mouse or pressing any key on the keyboard.
Check whether the signal cable is plugged in properly. Re-plug the signal cable if
l
necessary.
Reset the computer or video player.
l
Due to different video formats (aspect ratio) of DVDs, the monitor may display in full
l
screen.
Run the built-in diagnostics.
l
Possible Solutions
Advertisement
Table of Contents
