Maytag MVWB755YR0 Use And Care Manual page 12

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.maytag.com/help
for assistance and to possibly avoid a service call.
Check the following for Washer not level. Water may splash off basket if washer is not level.
proper installation:
Fill hoses not attached tightly. Tighten fill=hose connection.
Fill hose washers Make sure all four fill hose flat washers are properly seated.
Drain hose connection
Not enough water
in washer
Washer won't run or fill,
washer stops working
Check household plumbing
for leaks or clogged sink or drain.
Washer not loaded as
recommended.
Load not completely covered
in water.
Check for proper water supply.
k.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Do not place tape over drain opening.
Water can backup out of a clogged sink or drainpipe. Check all
household plumbing for leaks (laundry tubs, drain pipe, water pipes,
and faucets.)
An unbalanced load can cause basket to be out of alignment and
cause water to splash off tub. See "Using Your Washer" for loading
instructions.
This is normal operation for an HE low=water washer. The load will not
be completely underwater. The washer senses load sizes and adds
correct amount of water for optimal cleaning. See "What's New under
the Lid."
IMPORTANT: Do not add more water to washer. The added water lifts
the load off the impeller, resulting in less cleaning.
Both hoses must be attached and have water flowing to
inlet valve.
Both Hot and Cold water faucets must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water flow.
J
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
First try the solutions suggested here or visit our website at www.maytag.com/help
for assistance and to possibly avoid a service call.
If you experience Possible Causes Solution
Washer won't run or fill,
washer stops working
(cont.)
12
Check proper electrical supply.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.