Advertisement
our TV remote can be set to
work your Cable Converter
by
what is called the SEARCH
method.
If the "REMOTE
CODE" number
method
shown previously
did not
set your remote to work your
Converter,
then follow
the five
• easy steps listed below.
Please read through steps 1-5
before beginning.
_
Slide the TV-VCR-CBL
switch to CBL.
<_
Press the POWER button on
the Converter to turn Converter
ON.
Stand at least six feet away
<
from the front of the Converter.
Point the remote toward the
Converter.
HOLD DOWN the RESET and
A/CH buttons at the same time.
KEEP HOLDING BUTTONS
DOWN.
_
Watch
Channel Indicator
the
on the Converter.
Channel Numbers will SCAN UP
when the remote is ready to work
with the Converter. This may take
up to two minutes.
_
Release the RESET and A/CH
buttons as soon as channel
numbers start to scan up. The
remote is now ready to work the
Converter.
Remember. A minute or
two can seem very long, but
[ the code should be located within
I two minutes.
[ Don't let the Converter scan up
I more than five channels. If you do
] the remote may pass up the right
] code. Then another two minute
/ search cycle will have to be
repeated.
/ If no channel change happens
/ within two minutes, repeat steps !,-
[ 5. If-._zhannel-change still doesnt
occur, the remote will not operate
the desired Converter.
CABLECONVERTER
09
Don't let the converter
scan up more than five
channels (in Search
mode).
23
Six Feet
(minimum)
Advertisement
