Advertisement
our 73/remote
can be set to
work your VCR by what is
called the SEARCH
method.
If the "REMOTE
CODE" number
method
shown previously
did not
set your remote to work your VCR,
then follow
the five easy steps
listed below.
Please read through steps 1-5
before beginning.
<_
Slide the TV-VCR-CBL
I switch to VCR.
<_
Press the POWER button on
the VCR.
<_
Stand at least six feet
from
away
the front of the VCR.
Point the remote toward the
VCR.
HOLD DOWN the RESET and
AJCH buttons at the same time.
KEEP HOLDING BUTTONS
DOWN.
<_
Watch the Channel Indicator
on the VCR.
Channel Numbers will SCAN UP
when the remote is ready to work
with the VCR. This may take up to
two minutes.
<_
Release the RESET and
ALT/CH buttons as soon as
channel numbers start to scan up.
The remote is now ready to work
the VCR.
O
__tw
Remember. A minute or
o can seem very long, but
the code should be located within
two minutes.
Don't let the VCR scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search
cycle will have to be repeated.
If no channel change happens
within two minutes, repeat steps 1-
5. Should a channel change still
not occur, the remote will not
-._rate
the desired VCR.
VCR
09
Don't let the VCR scan
up more than five
channels. (in Search
mode).
•
RESET
SLEEP
POWER
T
Six Feet
(minimum)
22
Advertisement
