Healthrider aeROBICRIDER 2 User Manual page 6

5.
St
7.
.
Push the Magnet Bracket (36) into the hole in the
Pedal Frame (4).
Lubricate an M8 x 157mm Axle (13). Attach the
Pedal Frame (4) to the Main Frame (1) with the M8
x 157mm Axle, two Rubber Washers (51), and two
Axle Fasteners (56).
Attach the Left Side Shield (21) to the Seat Frame
(2) using three Tree Fasteners (45). If you can't
push the Tree Fasteners in with your fingers, tap
them in with a rubber mallet.
Attach the Right Side Shield (22, not shown) in the
same way.
While another person holds the Long Link Arm (10)
and the Short LinkArm (11) in place, put two Plastic
Washers (49) between them. Then, connect the
Seat Swing Arm (5), the Long Unk Arm (10), and
the Short UnkArm (11) using an M8 x 1.375" Bolt
(17) and an M8 Nylon Jam Nut (7).
Place the Seat (20) on the Frame (2). Slide the
Seat Washer (38) onto the Seat Knob Bolt (43) and
then tighten the Seat Knob (37) onto it.
Slide the Weight Bracket (8) onto tl_e Seat Frame
(2) so that it slants away from the AEROBIC RIDER
2. Align the holes in the Weight Bracket with the
ones in the end of the Frame. Insert the M8 x
120ram Bolt through the Weight Bracket and the
Frame and secure it with an M6 Nylon Jam Nut (7).
Lubricate_l 3
36" Hole
5
57
_37