Oven Temperature Control; Troubleshooting - Inglis KERI201PBL4 Use & Care Manual

3.
Slowly push the drawer into the range until the drawer side
rails engage with the gap in the drawer glides.
Once the drawer is fully engaged on both sides, slide the
drawer back into the closed position.
NOTE: When you are removing and replacing the storage
drawer, a slight push may be needed to move the drawer
stop notch past the drawer glides.
A. Engage drawer glide.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
• On some models, is the Control Lock set?
Nothing will operate See "Control Lock" section.
• Is the power supply cord unplugged? Oven temperature too high or too low
Plug into a grounded outlet. _........................................................
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Cooktop will not operate
• Is the control knob set correctly?
Push in knob before turning to a setting.
• Does the oven temperature calibration need adjustment?
See "Oven Temperature Control" section.
On some models, does the cooling fan run during BAKE,
BROIL or CLEAN?
It is normal for the fan to automatically run when the oven is
in use. This helps cool the electronic control.
Oven indicator lights flash
• On ceramic glass models, is the "Control Lock" set?
See "Control Lock" section.
Excessive heat around cookware on cooktop
• Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than 1/2"(1.3 cm) outside the cooking area.
Hot Surface indicator light stays on
• Does the Hot Surface indicator light stay on after control
knob(s) have been turned off?
See "Cooktop Controls" section.
Cooktop cooking results not what expected
• Is the proper cookware being used?
See "Cookware" section.
• Is the control knob set to the proper heat level?
See "Cooktop Controls" section.
• Is the appliance level?
Level the appliance. See the Installation Instructions.
Oven will not operate
• Is the electronic oven control set correctly?
See "Electronic Oven Controls" section.
Do the oven indicator lights flash?
See the "Display" and/or the "Oven Indicator Lights" section.
If the indicator light(s) keeps flashing, call for service. See
"Assistance or Service" section.
Display shows messages
Is the display showing "PF" or a flashing time?
There has been a power failure. Clear the display. See
"Display(s)" section. On some models, reset the clock, if
needed. See "Clock" section.
Is the display showing a letter followed by a number?
Depending on your model, press OFF/CANCEL, OFF or
CANCEL/OFF to clear the display. See "Display(s)" section. If
it reappears, call for service. See "Assistance or Service"
section.
Self-Cleaning cycle will not operate
• Is the oven door open?
Close the oven door all the way.
• Has the function been entered?
See "Self-Cleaning Cycle" section.
• On some models, has a delay start Self-Clean cycle been
set?
See "Self-Cleaning Cycle" section.
• Has a delay start been set?
See "Timed Cooking" section.
• Has a delay start been set?
See "Timed Cooking" section.
16