Canceling A Cycle; Changing A Cycle Or Setting - KitchenAid KUDS01IJBS0 Use & Care Manual

Light/
China Use this cycIeforchina and _]
crystal. Thiscycleuses a
light wash and gentledry.
Duringtheheated dry, the Use main
heatingelementcycleson detergent
and off. dispenser section.
Soil Rinse Main Rinse Purger Final Dry Time Water
Level Wash Heated (min) Usage
Sensed Rinse (gaUL)
•
I • • •
79* 7.1-8.6
Heavy 12g°F t35°F cycled /27-33
(49°C) (57°C)
• • • • •
71" 5.5/21
Light 120°F t35°F cycled
(49°C) (57°C}
Use this cycle for a quick wash t'--q[C]
and light dry to cleanup L_J] i
cookware prior to entertaining.
The sensor adds water and Use main
time to the cycle, if needed, for detergent
maximum cleaning. This cycle dispenser
uses a shortened dry time. section.
Towel drying may be needed.
Water Rinse Main Rinse Final Dry Time Water
Temp Wash Heated (min) Usege
Sensed Rinse (gal/L)
Hot
• • • •
44* 5.2-6.5
/20-25
Cold • • • • • 48* 7.1-8,21
27-31
Rinse
Use this rinse cycle for _]
Only
rinsing dishes, glasses, and
silverware that will not be
washed right away. Do not use
detergent with
this cycle.
Soil Pre- Rinse Main Rinse Final Dry Time Water
Level Wash Wash Heated (rain) Usage
Sensed Rinse (gal/L)
• 10 1.B/7
A small amount of water is run through the pump to remove
soil particles between the main wash and final rinse.
NOTES:
• The sensor in your dishwasher monitors the soil level. Cycle
time and/or water usage can vary from the numbers above as
the sensor adjusts the cycle for the best wash performance.
• In the Normal cycle, the dishwasher pauses while soaking.
Soaking helps loosen soils on dishes for brilliant results.
Anytime during a cycle, press
The display shows
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press Cancel/Drain before starting the dishwasher to clear all
options and cycles.
During the first minute of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle,
After the first minute of a cycle
1. Press
O
The display shows
Your dishwasher starts a 2 minute drain (if needed). Let
the dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Close the door.
4. Press a new cycle and/or options.
5. Press START.
13