Using Child Lock; Adding Dishes During A Cycle - KitchenAid Sculptura KUDR24SE Use & Care Manual

Using Child Lock
Child Lock Light
Use Child Lock to
prevent
your dishwasher
from being turned on
CHILD LOCK accidentally. No
wash selections or
options can be
selected when Child Lock is on, and the
dishwasher will not start.
NOTE: You will still be able to open the
dishwasher door.
To turn Child Loci< on
Press Energy Saver Dry for 5 seconds.
The Child Lock light will glow. All
other lights will be off.
To turn Child Lock off
Press Energy Saver Dry again for 5 seconds.
The Child Lock light will turn off.
Changing a sexing
During the first 2 minutes of
a cycle
Press new Wash Selection and Option pads.
After the first 2 minutes of"
a cycle
!. Press the Cancel pad to drain any water
and to reset the control.
2. Open the door and check the detergent
dispenser to be sure it is properly filled for
the new cycle.
3. Close the door.
4, Press new Wash Selection and Option
pads, then press the Start pad.
NOTE: If the dishwasher will not start, make
sure Delay Hours has not been selected.
Adding dishes during a cycle
You can add an item to the dishwasher
during the first 10 minutes of the cycle.
1. Unlatch the door to stop the cycle. Wait a
few seconds for the spray action to stop
before opening the door.
2. Open the door and add the dishes.
3. Close the door.
4. The dishwasher will start automatically
after a 5-second pause when you close
the door.