Advertisement
Available languages
Available languages
_lb
WARNING: Risk of electrical shock. Electrical
wiring must be done by qualified personnel
in accordance with all applicable codes and
standards.
Before connecting wires, switch
power off at service panel and lock service
disconnecting
means to prevent power from
being switched on accidentally.
1. Remove wiring cover from rough-in plate and set aside.
2. Remove appropriate
knock-out from rough-in plate. As you
are installing the rough-in
plate, feed 6" of power cable
through knock-out opening and attach cable to wiring box
with appropriate
connectors.
3. Connect BLACK to BLACK, WHITE to WHITE and GREEN
or bare wire under GREEN ground screw. Reinstall wiring
cover.
According
to your needs, 3 soffit chimney models are
available - to hide ductwork if the hood is not installed
under a cabinet.
The 12" high 51012 model is intended for kitchen with 8'
ceiling, the 24" high 51024 for 9' ceiling and the 36" high
51036 for 10' ceiling. Refer to the instructions included with
the soffit chimney.
Refer to
5 for
information.
1
page
ordering
J
1. To install blower, refer to instructions included with blower
/ rough-in kit. Once the blower is installed, plug the blower
unit into the female receptacle and the power supply onto
the male connector inside the hood. DO NOT plug the two
cords into each other.
See page 5 for blower/rough-in
kit information.
J
HEO078
2. Install the pan previously
removed inside the hood, and
secure with its 4 screws.
WARNING:
in order to prevent the risk of personal injury, do not install a lamp identified for use only in enclosed
fixtures.
This hood must use 120 V, 50W, MR16 with GU10 base or PAR 16 with GU10 base, shielded halogen lamps (included).
Refer to page 4 for ordering
information.
]
WARNING:
in order to prevent the risk of personal injury, the halogen lamps must be cooled down before removing
them.
1. To remove
lamps,
gently
push
upwards
and
turn
counterclockwise
to disengage
bulb leads from their
grooves.
If need be, use a rubber dishwashing glove to add grip
when removing the bulb.
2. Install the new lamps by placing the bulb leads into their
grooves in the socket.
1
2
3
3. Gently push upwards and turn clockwise until secure.
10
Advertisement
