Installation Information - Kenmore ELITE 125.16651900 Use & Care Manual

FOR OUTDOOR USE ONLY.DO NOT
operate indoors or in an enclosed area
such as a garage, shed or breezeway.
Useyour grill OUTDOORSin a well
ventilated space awayfrom dwellings or
other buildings to prevent dangers
associated with gas accumulation and toxic
vapors.Although minimum clearanceis
36 inches (91 cm), we strongly recommend
that you do not operate this appliance within
10
ft. (3.0 m) of any structure, combustible
material or extra LP gas cylinders not
attached to the appliance. Not adhering to
these clearances will prevent proper
ventilation and may increase the risk of a fire
and/or property damage, which could also
result in personal injury.
Maintain a minimum clearance of
36 inches (91 cm) between all sides
of grill, deck railings, walls or other
combustible material. DO NOT use grill
under overhead unprotected combustible
construction.
• LP GAS CYLINDER (NOT SUPPLIED WITH
THIS GRILL).
• The LP cylinder is available for purchase at the
same location the grill was purchased
The LP (Liquid Propane) gas cylinder
specifically designed to be used with this grill
must have a 20 lb. (9.1 kg) capacity
incorporating a Type 1 cylinder valve and an
over-filling protection device (OPD).
This grill is designed to fit Worthington,
Manchester or SMPC brand 20 lb. (9.1 kg)
cylinders. Other brand DOT cylinders may fit
this grill if the cylinder has similar dimensions
of the top and bottom rings.
DO NOT connect this grill to an existing #510
POL cylinder valve with Left Hand threads. The
Type 1 valve can be identified with the large
external threads on the valve outlet.
DO NOT connect to a propane cylinder
exceeding this capacity.
DO NOT connect to a cylinder that uses any
other type of valve connection device.
INSTALLATION INFORMATION:
The installation of this appliance must be in
accordance with:
All applicable local codes, or in the absence of
local codes, either:
• National Fuel Gas Code - ANSI-Z223.1 NFPA 54
• Natural Gas and Propane Installation Code:
CAN/CGA B149.1
• Propane Installation Code: CAN/CGA B149.2
(Canada)
To check your local codes, see your local LP gas
dealer. This appliance is adjusted and shipped for use
with LP gas. If an external electrical source is utilized,
it must be electrically grounded in accordance with
local codes, or in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA 22.1 and a minimum
15 amp supply is needed.
Stainless Steel Wire
Warming Rack
Stainless Steel
Cooking
4 Stainless Steel
Burners
Smoker Burner
7,500 BTUs
Stainless Steel
Side Burner
3