Advertisement
Available languages
Available languages
1.
2.
3.
Install the round damper into the duct connector of the
range hood.
Hang the hood from the bracket through the
rectangular
cut-out on the back of the hood. Cut-out
is larger than the bracket to allow for horizontal
adjustment.
The bottom of the hood should be 24" to 30" above
the cooking surface.
Attach (2) hood height / angle adjustment
screws
(3,9 × 9,5 ram) to hood bracket. Use these screws to
level the hood.
ROUND DAMPER
4.
Secure the hood with mounting
screws (4,8 × 3,8
ram). Use drywall anchors, provided, if wall studs or
framing are not available.
HEIGHT
ADJUSTMENT
ADDITIONAL
MOUNTING
WALL FRAMING
_MOUNTING
BRACKET
RECTANGULAR
CUTOUT
Note: This range hood must be properly grounded. The
unit should be installed by a qualified electrician
in
accordance
with all applicable
national and local
electrical
codes.
GROUNDING INSTRUCT]ONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and
grounded.
WARNING - Improper grounding can result in a risk of
electric shock.
Consult a qualified electrician if the grounding
instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician install an outlet near
the appliance.
(85cm)
max
Set the electrical power supply within the space covered
by the decorative flues.
Position the power socket at a maximum distance of 33-
7/16" (85 cm) from where the lead exits from the hood
(see illustration alongside). Make sure this does not
interfere with the bracket fastening area or with the
decorative flue (where the flue touches the wall).
Fit the plug into the power socket.
Advertisement
