Pause And Pour Feature; Setting The Clock, Timer And Auto-Brewing - Kenmore ELITE 1009101770A Use & Care Manual

BREWING COFFEE cont.
3. Place either the permanent gold-tone filter
or a size 1 X 4 paper filter into the brew
basket (see Fig. 5).
4. Add ground coffee. The amount of coffee
you use is a matter of personal taste
(we recommend one heaping tablespoon
for every two cups).
Experiment... try different amounts of
ground coffee per cup until you brew your
perfect cup of coffee. You can also try using
the paper filter along with the gold-tone filter.
.
Fig. 5
Close the cover. Place carafe on the plate
and plug in the appliance. The display
window illuminates blue and the coffeemaker beeps for about 3 seconds
to let you know the clock is not set. The clock does not have to be set to brew coffee.
To set the clock time, see SETTING THE CLOCK, TIMER AND AUTO-BREWING.
6. Turn on the coffeemaker by pushing in the BREW ON/OFF button. The ON/OFF button
will illuminate blue and the word Brew will show up in the control panel display showing
that the coffeemaker is brewing. In a few seconds, hot water flows into the filter. When
the water has stopped flowing, the coffeemaker's blue BREW ON/OFF light goes out.
The Time Since Brew function begins to keep track of the freshness of the coffee in
the carafe. For delayed brewing, see SETTING THE CLOCK, TIMER AND
AUTO-BREWING.
7. When you have poured out all the coffee in the carafe, press the BREW ON/OFF
button to turn off the appliance's Time Since Brew function.
NOTE: If the coffeemaker is not turned off, it will automatically shut itself off
after two hours.
PAUSE AND POUR FEATURE
The pause and pour feature enables you to remove the carafe from the Coffeemaker and
pour a cup of coffee before brewing is finished. When the carafe is removed, a special
valve stops the flow of coffee from the brew basket to the carafe. Brewing does not stop.
If the carafe is not replaced under the brew basket after 20 seconds, water and coffee
will overflow from the brew basket.
SETTING THE CLOCK, TIMER AND AUTO-BREWING
USE THE Set Clock Button TO SETTHE CLOCK:
1. Press Set Clock button and the button's indicator light will flash.
2. Set the time of day by pressing the Hour and Minute buttons. Be sure to set the time
with the correct AM and PM designation.
3. You can make the hours and minutes move more quickly in the clock display by
holding the buttons down.
4. If you press the Set Clock button and don't do anything for 5 seconds, the button's
light flashes 5 times then turns off. To resume, press the Set Clock button again.
The clock starts a few seconds after you finish setting it.