Advertisement
Before Setting Oven
Controls
Arranging
Oven
Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIORTO
OPERATING THE OVEN). Always use oven mitts when using the oven,
Oven Vent Location
The oven vent is located
under the right rear surface
element.
When the
oven is on, warm air is released through the vents. This venting is necessary
for proper air circulation in the oven and good baking results.
REMOVING
& REPLACING OVEN RACKS
To remove,
pull the rack forward
until it stops. Lift up
front of rack and slide out. To replace,
fit the rack onto
the guides on the oven walls. Tilt the front of the rack
upward and slide the rack back into place.
ARRANGING
OVEN RACKS WITH 5 RACK POSITIONS
To bake on 1 rack, place the rack on position 3 or 4. To
bake on 2 racks, place the racks on positions 2 and 4.
l_t Rack Position
2nd Rack Position
3rd Rack Position
4th Rack Position
5th Rack Position
Setting Oven Controls
-1-
Note:
The oven function will not
work if the time of day clock is not
set.
Note:
The oven control has a built-in
safety feature that will shut off the
oven if the control is left on for more
than 11 hours 59 minutes.
To Set or Change
the Temperature
for Normal
Baking
The oven can be programmed to bake at any temperature from 170°F to
550°F (65°C to 287°C).
To Set the Controls for Normal
Baking:
1.
Push _.
"
." appears in the display.
2.
Within 5 seconds, push the []
or _).
The display will show "350°F
(177°C)." By holding the []
or _,
the temperature
can then be
adjusted in 5°F (1°C) increments.
3.
As soon as the []
or _
is released, the oven will begin heating to
the selected temperature.
When the displayed temperature
reaches the
desired baking temperature,
the control will beep 3 times.
4.
To cancel the baking function,
push [].
¥o Change
the Oven Temperature
after Baking has Started:
you are using the minute timer, push _
and make sure the bake
1.
If
temperature
is displayed.
the _)
or (_
to increase or decrease the set temperature.
2.
Push
9
Advertisement
