Advertisement
Changing
Cooktop
and/or Oven Lights
(some models)
[Ir_'_ll_rilt'_
Be sure the range is unplugged
and all parts are COOL before
replacing the oven light. Wear a leather-faced
glove for protection
against
possible broken glass.
To Change
the Oven
Light
(some
models)
On some models, the oven light automatically
turns on when the door is
opened. Some models have a switch located on the control panel to turn
on the light. The oven light is located at the rear of the oven and is covered
with a glass shield held by a wire holder. The glass shield must be in place
whenever the oven is in use.
To replace
the oven light:
1.
Turn electrical power off at the main source or unplug the range.
2.
Press wire holder to one side to release the glass shield.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug the range back
in).
6.
The clock(if equipped)
will then need to be reset. To reset, see Setting
the Clock and Minute
Timer in this Owner's Guide.
Adjusting
Oven
Temperature
Note: The adjustments made will not
change the se f-c eaning temperature.
The temperature
control
in the oven has been set at the factory. When first
using the oven, be sure to follow recipe times and temperatures.
If you
think the oven is too hot or too cool, the temperature
in the oven can be
adjusted.
Before adjusting, test a recipe by using a temperature
setting that
is higher or lower than the recommended
temperature.
The baking results
should help you to decide how much of an adjustment
is needed.
To Adjust Oven Temperature:
1.
Push _).
2.
Set the temperature
to 550°F (287°C) by pushing and holding the _.
seconds, push and hold _
until the special 2 digit display
3.
Within 2
appears. Release (_.
The display now indicates the amount
of
degrees offset between the original factory temperature
setting and the
current temperature
setting.
If the oven control has the original factory
calibration,
the display will read "00."
4.
The temperature
can now be adjusted up or down 35°F (17°(:), in 5°F
(1°C) steps, by pushing and holding the []
or (_.
Adjust
until the
desired amount of offset appears in the display.
5.
When you have made the desired adjustment,
push _
to go back to
the time of day display. When adjusting oven temperature,
a minus
sign (-) will appear before the number to indicate that the oven will be
cooler by the displayed amount of degrees.
nl
I--
m
Uq
:Z:
17
Advertisement
