Table of Contents
Advertisement
SAVE THESE mHSTRUCTION$
Read
agg instructions
before
using
_his
appR_ance,
When
using
gas or e_ectr_caJ
appliances,
basic
safety
precautions
should
be foilowed,
_ncaud_ng
the
fo_aowHng:
Outside
Edge Of
Bracket
To Be
With Le_ O_
Right Side Of Rango
:
Toons you will need:
• Phillips head screwdriver
o 1 3/8" open end or adjustable wrench
m
m
11
Remove the bracket from the
prepack located inside the oven.
Decide whether the bracket will be
installed on the right or left side of
range location.
tf the bracket side of the range is
adjacent to a cabinet, place the
bracket against back wall and
cabinet
as shown in Figure 1.
tf there is no adjacent
cabinet,
determine
where the location of
the range side (painted outside
panel) will be. Piace the bracket
with its outside edge at this
location and against back Wall.
See Figure 2.
Determine
whether you will anchor
the bracket to the floor or wall.
Make sure this location is clear of
electrical
wiring or plumbing.
Fig, t
m
Fig, 2
Fasten the bracket securely with
the screws provided.
Screws are
self-drilling
in wood, plywood,
particle and chip board, and most
metal framing. If attaching to
masonry, you can buy suitable
screws and anchors at hardware
stores. Use a masonry drill bit to
drill the required holes.
Wall
Plate
Attachment To Wall
a
u
Using the wrench, back out the
four leg levelers at least two turns.
See your installation
guide for
more leveling information
before
positioning
range.
Slide the range into place. Be sure
rear leg leveler fully engages
the
slot in the bracket. If range cannot
be moved back far enough for
rear leg leveler to enter bracket,
move bracket forward as required
and attach to floor in new location.
3
Advertisement
Table of Contents
