Table of Contents
Advertisement
Connecting the Unit
This section describes how to connect the main video
camera, display, microphone, LAN cable and power
cord.
E
To a switching hub
C
A
To each device
Notice
•
Use only the included power cord.
Note
•
Make sure to read the instruction manuals for
all devices being connected.
1.
Connect the main video camera.
•
Connect the main video camera to the Main
Camera terminal on the back of the unit using
an HDMI cable (A).
2.
Connect the display.
•
Connect the display to the HDMI terminal on the
back of the unit using an HDMI cable (B).
F
To earthed
AC outlet
D
B
To a display
Note
•
If your display is not compatible with HDMI,
use a component cable (Page 24). Since
sound signals are not transmitted when
using a component cable, connect an
amplifier/active speaker (Page 23).
3.
Connect a microphone.
Boundary Microphone (optional)
Connect the Boundary Microphone to the MIC jack
on the back of the unit using the proprietary cable
(C).
•
Use only the included cable.
•
Push and turn the connector of the proprietary
cable until it clicks. If the connector does not
click, try reconnecting the cable with the top and
bottom of the connector reversed.
General-purpose microphone
Connect the microphone to the Audio In L/R jack on
the back of the unit using the stereo pin plug cable
(D) after amplifying the signal to line level using a
device such as a microphone amplifier.
•
Connect the microphone correctly, as follows:
Left channel ® L
–
–
Right channel ® R
Note
•
When connecting both the Boundary
Microphone and a general-purpose
microphone, both microphones can be used
simultaneously.
4.
Connect to the network.
•
Connect a switching hub to the LAN jack on the
back of the unit using a category 5 or greater
LAN cable (E).
Note
•
Set the switching hub to Auto Negotiation
mode.
•
If the system is set to 100M Full Duplex, it
is necessary to change the system setting.
For details, contact your dealer.
•
Do not connect to a switching hub set to Half
Duplex.
•
For more details about switching hubs, refer
to the documentation for the switching
hubs.
5.
Insert the included power cord (F) into the AC IN
terminal on the back of the unit.
•
Use only the included power cord.
Preparation
User Manual
21
Advertisement
Table of Contents
