Belt Guard - Pfaff GrandQuilter 18.8 Owner's Manual

Belt guard

Your machine comes with a belt guard to prevent damage to your motor sensor and protect you from getting
caught in the belt. In the box you will find the plastic cover and attached to the machine are the screws used to
hold the belt guard in place.
Step 4. Replace the three screws so that they hold the belt guard in place.
Step 1. Locate the screws on the machine there are two
above the hand wheel and one can be found below the
hand wheel.
Step 2. Remove the three screws.
Step 3. Locate the belt guard and position over the hand
wheel and the motor.
This photo shows the belt guard in place and how it
protects the motor sensor and the belt.
6