Table of Contents
Advertisement
Buttonhole mode button
The Buttonhole mode button is used for toggling
between slit length (A), density (B) and balance (C)
mode when a buttonhole is selected.
If the buttonhole will be sewn manually only the
balance and density modes are available.
Use the stitch length buttons (52) to change the set-
tings in the currently active mode.
The settings will remain until another stitch is
selected.
Buttonhole length
When a buttonhole is selected the machine auto-
matically enters the buttonhole slit length mode.
The buttonhole slit length icon and the slit length is
shown on the window.
Change the slit lenght by pressing the stitch length
buttons (52). Remember to always set the length
little bit longer than the button diameter.
Buttonhole density
By adjusting the density of the buttonhole you can
change the closeness of the satin stitches without
changing the length of the complete buttonhole.
Press the - stitch length button (52) to increase
the density and the + stitch length button (52) to
decrease the density.
Buttonhole balance
The balance adjusts the forward and backward feed-
ing of the machine. If the machine is unbalanced the
right and left columns of the buttonhole will be sewn
uneven.
Press the - stitch length button (52) to adjust the
backward feeding, this increases the density in the
left column. Press the + stitch length button (52) to
adjust the forward feeding, this increases the density
in the right column.
4:6
A
B
C
Hide quick links:
Advertisement
Table of Contents
