Water Filter Certifications - Whirlpool GZ25FSRXYY0 User Instructions

Are there minerals (such as sulfur) in the water? A water
filter may need to be installed to remove the minerals.
Water filter installed on the refrigerator? Gray or dark
discoloration in ice indicates that the water filtration system
needs additional flushing. Flush the water system before using
a new water filter. Replace water filter when indicated. See
"Water Filtration System."
The water and ice dispenser will not operate properly
• Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water
supply and turn water shutoff valve fully open.
• Kink in the water source line? Straighten the water source
line.
New installation? Flush and fill the water system. See "Water
and Ice Dispensers."
Is the water pressure at least 35 psi (241 kPa)? The water
pressure to the home determines the flow from the dispenser.
See "Water Supply Requirements."
Water filter installed on the refrigerator? Remove filter and
operate dispenser. If water flow increases, the filter may be
clogged or incorrectly installed. Replace filter or reinstall it
correctly.
Water dispenser measured fill feature is not dispensing an
accurate amount of water? Calibrate the water dispenser.
See "Water and Ice Dispensers."
Refrigerator door closed completely? Close the door firmly.
If it does not close completely, see "The doors will not close
completely."
Recently removed the doors? Make sure the water
dispenser wire/tube assembly has been properly reconnected
at the top of the refrigerator door. See "Refrigerator Doors and
Drawer."
• Reverse osmosis water filtration system connected to
your cold water supply? This can decrease water pressure.
See "Water Supply Requirements."
Water is leaking from the dispenser system
NOTE: One or two drops of water after dispensing is normal.
• Glass not being held under the dispenser long enough?
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
New installation? Flush the water system. See "Water and
Ice Dispensers."
Recently changed water filter? Flush the water system. See
"Water and Ice Dispensers."
Water from the dispenser is warm
NOTE: Water from the dispenser is only chilled to 50°F (10°C).
• New installation? Allow 24 hours after installation for the
water supply to cool completely.
Recently dispensed large amount of water? Allow 24 hours
for water supply to cool completely.
Water not been recently dispensed? The first glass of water
may not be cool. Discard the first glass of water.
Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements."
WATER FILTER CERTIFICATIONS
State of California
Department of Public Health
Water Treatment Device
Certificate Number
03- 1583
Date Issued: Seplcmber 16, 2008
Date Revised: April 22, 2009
The water treatment,
Carbofhran
p-dichlorobenzene
Toxaphene
Tetrachloroethylene
Rated Service Capacity: 750 gal. Rated Service Flow: 0.78 gpm
Conditions of Certification:
Do not use where water is microbiologically unsafe or with water of unknown quality, except that systems certified
for cyst reduction may be used on disinfected waters that may contain filterable cysts
State of California
Department of Public tlealtb
Water Treatment Device
Certificate Number
09- 1979
Date Issued: May 8, 2009
Date Revised: 6/22/2010
UKF8001 AXX-200
Replacement Elements
UKI_8001
46 9006
Cysts
"" rb d ty
Alrazine
Benzene
Carbolitrar_
Chlorobenzen?
Endrin ;
I tb ,b .......
Lindane "
Rated Service Capacity! 20_ gal )0 55 _pm
_naiiioas 6t C_ifififiltia_: :
Do not use where water is microbiolt_gicafly _asafe gr Ntfi _r o_ unkg0wn quality, except that systems
certified lbr cyst reduction may be ased _h disi_ft_cied filterable cysts.
17