KitchenAid KIRD802HSS1 Use And Care Manual page 9

6[] Turnthe controlknobon
sideof ventto checkthe
operationandspeedof blower.
If blowerdoesnot operate:
• Check that filter or filters are
pressed in asfar as theywill go.
Check that circuitbreakeris not
tripped or housefuse blown.
Disconnect p ower.Check that
wire connections havebeen
madecorrectly.
• Reconnect power.
7= Connect v ent systemto
blower. V entsystemmustendwith
a wall or roof cap.Useduct tapeto
sealalljoints.
18= Installcooktopaccording
to manufacturer's i nstructions,
Check thatrearof cooktopoverlaps
edgeof retractable downdraftvent
by 3/8"(9.5mm).
To get the most efficient use
from your new retractable
downdraft vent, read the Use
and Care Information section
on page 12.
Keep Installation Instructions
and Use and Care
Information close by for
easy reference.
KIRD and YKIRD
MODELS ONLY
NOTE: Exterior-mounted vent
motor installations require exterior
blower system, Model No.
KPEC992M [900 cfm (25.5 m3/m)],
available from your dealer or
authorized parts supplier.
iMPORTANT: Exterior blower
Model No. KPEU722M [1200 cfm
(34.0 m3/3)] cannot be used with
this retractable downdraft vent
system.
island location
Built-in cabinet location
Built-in cabinet location
Roof venting
L_______F
'\\ ,
10" (25.4 cm)
round vent
Maximum length of vent
system
Vent Length
10" (25.4 cm) round 40 ft. (12.2 m)
Vent length is given as a general
reference only. For a longer vent
run, or smaller vent system,
contact a qualified and trained
vent installer. Check with local
codes for makeup air
requirements, if any.
For best performance, use no more
than three 90 ° elbows. If more than
one elbow is used, make sure that
there is a minimum of 24 inches
(61 cm) of straight vent between
any two elbows. Do not install two
elbows together.
It is recommended that you use
round vent instead of rectangular
vent, especially if elbows are
required. If rectangular vent is
required, it should be transitioned
to 10" (25.4 cm) round vent as
soon as possible.
Determining the length of system
you need:
To calculate the length of system
you need, add the equivalent feet
for each duct piece that will be
needed. See example for 10"
(25.4 cm) round vent system.
10" (25.4 cm} round
vent system
E
Maximum length = 40 ft. (12.2 m)
2 - 90 elbows
10 ft. (3 m) straight
Length of 10"
(25.4 cm) system
= 10 ft. (3.05 m)
= 10 ft. (3.05 m)
= 20 ft. (6.1 m)
NOTE:The exterior-mounted vent
motor requires a separate wiring
cable that should be installed at
the same time the vent work is
installed.
left vent right vent 9