Table of Contents
Advertisement
IMPORTANT: Observe all
governing
codes and ordinances.
It is the customer's
responsibility:
eTo contact a qualified
electrical
installer.
• To assure that the electrical
installation
is adequate
and in
conformance
with National
Electrical Code, ANSI/NFPA 70
-- latest edition*,
or CSA
Standards
C22.1-g4, Canadian
Electrical Code, Part 1 and
C22.2 No. 0-M91 - latest
edition**
and all local codes
and ordinances.
If codes permit and a separate
ground wire is used, it is
recommended
that a qualified
electrician
determine
that the
ground
path is adequate.
Do not ground to a gas pipe.
Check with a qualified
electrician
if
you are not sure downdraft
vent is
properly
grounded.
Do not have a fuse in the neutral
or ground
circuit.
IMPORTANT: Save installation
instructions
for electrical
inspector's
use.
AB
A 120-volt,
60-Hz, AC-only,
fused
electrical
supply
is required
on a separate
15 amp
circuit.
A
time-delay
fuse or circuit
breaker
is recommended.The
fuse
must
be sized per local
codes
in
accordance
with
the electrical
rating
of the downdraft
vent
as
specified
on the model/serial
rating
plate
located
on the front
of the downdraft
vent
above
the
wiring
box cover.
B_
The downdraft
vent must
be connected
with copper wire
only.
C_
Wire sizes and connections
must conform
to the
requirements
of the National
Electrical
Code, ANSI/NFPA 70 --
latest edition*,
or CSA Standards
C22.1-94, Canadian Electrical
Code, Part 1 and C22.2 No. 0-M91
- latest edition**
and all local
codes and ordinances.
WARNING -- TO REDUCE THE
RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO
PERSONS, OBSERVE THE
FOLLOWING:
installation work and electrical
wiring must be done by qualified
person(s) in accordance with all
applicable Codes and Standards,
including fire related construction.
Sufficient air is needed for proper
combustion and exhausting of
gases through the flue (chimney)
of fuel burning equipment to
prevent back drafting. Follow the
heating equipment
manufacturer's guideline and
safety standards such as those
published by the National Fire
Protection Association
(NFPA),and the American Society
of Heating Refrigeration and Air
Conditioning Engineers
(ASHRAE), and the local code
authorities.
When cutting or drilling into wall
or ceiling, do not damage
electrical wiring and other hidden
utilities.
Ducted fans must always be
vented to the outdoors.
WARNING --To
reduce the risk
of fire, use only metal ductwork.
This unit must be grounded.
This downdraft
vent should
be connected
directly to the fused
disconnect
(or circuit
breaker)
through
flexible,
armored
or non-
metallic
sheathed,
copper cable.
Allow some slack in the cable so
the downdraft
vent can be moved
if servicing
is ever necessary.
E.,
A U.L.- or C.S.A,-listed,
1/2"
(12.7 mm) conduit connector
must be provided
at each end of
the power supply cable (at the
downdraft
vent and at the
junction
box).
Awiring
diagram
is located
on the downdraft
vent base
above the wiring
box cover.
Copies of the standards
listed may be
obtained
from:
* National
Fire Protection
Association
One Batterymarch
Park
Quincy, Massachusetts
02269
**CSA International
8501 East PleasantValley
Road
Cleveland,
Ohio 44131-5575
Advertisement
Table of Contents
