Loading Silverware Basket - KitchenAid KUDS011L Use & Care Manual

To install medium insert
1. Place the medium insert end legs under the 2nd from the
right wire as shown below.
SURE-HOLD
TM
mesh sack
This sack hangs on the front of the bottom rack. Use it to hold
small items that could otherwise "fly" around inside the
dishwasher during a cycle.
2=
Fr I T_ .......
IMPORTANT: Make sure that the curved wires, on the bottom
of the insert, fit over a wire in the bottom of the rack as
shown.
Push down on insert until handle fits against outer rack edge.
Load the silverware basket while it is in the bottom rack or take
the basket out for loading on a counter or table. (See
recommended loading pattern shown.)
NOTE: Unload or remove the basket before unloading the racks
to avoid spilling water droplets on the silverware.
• Load items with covers down, using the separators, to
prevent silverware nesting.
• Place small items such as baby bottle caps, jar lids, corncob
holders, etc., in the section(s) with hinged cover(s). Close the
cover to hold small items in place.
3. When center tab under handle locks in under the middle side
rack wire, the insert is in place. (See illustration.)
To install small insert
Front view from inside rack
1. Place small insert in front of rack so that the feet on the back
of the insert hook under the 2nd wire from the front, and the
curved front edge of the insert is aligned with the center wire
on the front side of the rack. (See illustration.)
2. Push down on insert until handle fits against outer rack edge.
• When covers are up, mix items in each section of the basket
with some pointing up and some down to avoid nesting.
Spray cannot reach nested items.
IMPORTANT: Always load sharp items (knives, skewers, etc.)
pointing down.
NOTES:
• Do not load silver or silver-plated silverware with stainless
steel. These metals can be damaged by contact with each
other during washing.
• Some foods (such as salt, vinegar, milk products, fruit juices,
etc.) can pit or corrode silverware. Run a rinse cycle if you do
not have a full load to wash immediately.
Front view from inside rack
3. When center tab under handle locks in under the middle side
rack wire, the insert is in place. (See illustration.)
11