GE JTS10 Owner's Manual page 16

Care and cleaning of the oven,
j j SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical
AWARNING j
powerto the oven at the main fuse or circuit breaker paneI. Failure to do so may result
in electric shock or burn.
[,& CAUTION
I URN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with bare hands or a damp cloth can cause burns.
ReceD_a@_ .Socket
_" G6.35 Bulb
on some moaels
ReceD_a@e
Socket
_G9 Bulb
Tab
Oven Light Replacement
To remove:
[-_ Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear
the grooves of the socket.Wearing latex
gloves may offer a better grip.
[] Using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
[Z] use a new 120/130-volt halogen bulb, not
to exceed 50 watts. Replacethe bulb with
the same type of bulb that was removed.
Your model will have one of the two types
shown on the left.To determine the correct
replacement bulb, check the bulb terminals.
Bulbswith 2 straight pin terminals are
G6.35bulbs. Bulbswith 2 looped terminals
are G9 bulbs. (Do not interchange.) Be sure
the replacement bulb is rated 120 volts or
130 volts (NOT12 volts).
Using gloves or a dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oil from skin will
damage the bulb and shorten its life.
@
%
@
bk% : $/¸¸::¸¸¸¸¸¸¸¸¸¸¸¸¸%¸¸¸
: ii
Receptac e
Qr
Pushthe bulb straight into the receptacle
all the way.
Placethe tabs of the glass cover into the
grooves of the socket.Turn the glass cover
clockwise 1/4 turn.
For improved lighting insidethe oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
Reconnect electrical power to the oven.
_nsome models)
Oven Light Bulb tonsomemodels)
m i
JMax
/ "'_:
I_engtK \ ):
,Bulb,
m
m
NOTE:Theglass cover (on some models)should
be removed only when cold.Wearing latex gloves
may offer a better grip.
Before replacing the bulb, disconnect electrical
power to the oven at the main fuse or circuit
breaker panel. Letthe bulb cool completely
before removing it. For your safety, do not
touch a hot bulb with a damp cloth. If you do,
_i the bulb will break.
To remove:
@lass cover Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear the
grooves of the socket. Removethe bulb.
16
To replace:
Put in a new 40-watt appliance bulb. Placethe
tabs of the glass cover into the grooves of the
socket. Turn the glass cover clockwise 1/4 turn.
NOTE:
A 40-watt appliance bulb is smaller than a
standard 40-watt household bulb.
Install and tighten the cover clockwise.
Reconnect electrical power to the oven.
For improved lighting inside the oven, clean
the glass cover frequently using a wet
cloth. This should be done when the oven is
completely cool.