Location; Model - GE JGB3000 Owner's Manual & Installation Instructions

Installation Instructions
A WARNING!
ANTI-TIP DEVICE
• All ranges can tip.
• BURNSor other SERIOUS
INJURIEScan result.
• INSTALL and CHECKthe
ANTI-TIP bracket following
the instructions supplied
with the bracket.
To reduce the risk of tipping the range, the range must
be secured by a properly installed anti-tip bracket. See
installation instructions shipped with the bracket for
complete details beforeattempting to install.
To check if the bracket is installed and engaged properly,
carefully tip the range forward. Thebracket should stop
the range within 4 inches.If it does not, the bracket must
be reinstalled.If the range is pulled from the wall for any
reason, always repeat this procedure to verify the range
is properly secured by the anti-tip bracket.
For flee-standing or slide-in ranges, never completely
remove the levelinglegs or the range will not be secured
to the anti-tip device properly.
If you did not receive an anti-tip bracket with your
purchase,call 2.800.626.8774to receiveone at no
cost fin Canada, call 2.800.562.3344). F or installation
instructions of the bracket, visit GEAppliances.com
(in Canada, GEAppliances.ca).
• For your safety, never use your range for warming
or heating the room. Your oven and cooktop are not
designed to heat your kitchen. Top burners should
not be operated without cookware on the grate. Such
abuse could result in fire and damage to your range
and will void your warranty.
• Do not store or use combustible materials, gasoline
or other flammable vapors and liquids in the vicinity
of this or any other appliance. Explosions or fires
could result.
• Do not use oven for a storage area. Items stored
in the oven can ignite.
• Do not let cooking grease or other flammable
materials accumulate in or near the range.
LOCATION
Do not locate the range where it may be subject to
strong drafts. Any openings in the floor or wall behind
the range should be sealed. Make sure the openings
around the base of the range that supply fresh air for
combustion and ventilation are not obstructed by
carpeting or woodwork.
Your range, like many other household items, is heavy and
can settle into soft floor coverings such as cushioned vinyl
or carpeting. Use care when moving the range on this type
of flooring. It is recommended that the following simple and
inexpensive instructions be followed to protect your floor.
The range should be installed on a sheet of plywood
(or similar material). When the floor covering ends at
the front of the range, the area that the range will rest
on should be built up with plywood to the same level
or higher than the floor covering.
This will allow the range to be moved for cleaning
or servicing. Also, make sure your floor covering will
withstand Z80°R(Seethe Installation SafetyInstructions
section.)
Hake sure the wall coverings around your range can
withstand the heat generated (up to 200°F)by the range.
(Seethe Installation SafetyInstructions section.)
IMPORTANT!
Remove all tape and packaging. Make sure the burners
are properly seated and level.
Lift up the cooktop Ion models with standard twin
burners} and remove any packing material under it.
Take the accessory pack out of the oven andlor drawer.
Check to be sure that no range parts have come loose
during shipping.
36