Oven; Oven Control - GE JGB3000 Owner's Manual & Installation Instructions

Using the ovencontrols.
Throughout this manual, features and appearance may vary from your model.
en Contrails
/
Temp Recall
0
Coot:s
["Kltche n_ ["-Cioc k-"_
k_Tim k2..... LJ
On / Off
('_-Oven-_ ['c-o°: i n g_ [r st_ rt-"_
k TimeJkTimeJ
10
OvenControl,Clockand TimerFeaturesand Settings
(onsome models)
Bake/Temp Recall Pad
Touch this pad to select the bake function.
Bake Light
Flasheswhile in edit mode-you can change
the oventemperature at this point. Glowswhen
the oven is in bakemode.
Start/On Pad
Must be touched to start any cooking or cleaning
function.
Display
Shows the time of day, oven temperature,
whether the oven is in the bake, broil or
self-cleaning mode and the times set for
the timer or automatic oven operations.
The display will show PREwhile preheating.
When the oven reaches the selected
temperature, the oven control will beep and
the display will show the oven temperature.
If "F-" and a number or letter flash in the display
and the oven control signals,this indicates a function
error code.
If your oven was set for o timed oven operation
and a power outage occurred, the clock and all
programmed functions must be reset.
Thetime of day will flash in the display when there
has been a power outage. Resetthe clock.
If the function error code appears during the
self-cleaning cycle,check the oven door latch. The
latch handle may have been moved, even if only
slightly, from the latched position. Make sure the
latch is moved to the right as far as it will go.
Touch the Clear/Off pad. Allow the oven to cool
for one hour. Put the oven back into operation.
If the function error code repeats, disconnect
the power to the range and call for service.
Kitchen Timer On/Off Pad
Touch this pad to select the timer feature.
Then press the + and - pads to adjust the timer.
Timer Light
Flasheswhile in edit mode-you can change
the set time at this point. Glowswhen the timer
has been activated. Flashesagain when the time
has run out until the control is reset.
Clock Pad
To set the clock, press this pad twice and then
press the + and - pads. The time of day will
flash in the display when the oven is first
turned on.
Start Time Pad (on some models)
Use along with the Cooking Time or Self Clean
pads to set the oven to start and stop
automatically at a time you set.
Start Time Light
Flasheswhile in edit mode-you can change
the start time at this point. Glowswhen the
function has been activated.
Cooking Time Pad (on some models)
Touch this pad and then touch the + or - pads
to set the amount of time you want your food
to cook. The oven will shut off when the
cooking time has run out.
Cooking Time Light
Flasheswhile in edit mode-you can change
the set time at this point. Glowswhen the
function has been activated. Flashesagain when
the time has run out until the control is reset.