Generalcleaning - Frigidaire FEC30C4ABA Owner's Manual

Electrolux
Table of Contents

Advertisement

Available languages

Available languages

General Cleaning
(Continued)
Cleaning
Various Parts of Your Cooktop
Before cleaning any part of the cooktop,
be sure all controls are turned OFF and the cooktop
is COOL. REMOVE SPILLOVERS AND
HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCE THE NUMBER OF MAJOR CLEANING LATER.
Surfaces
How to Clean
Aluminum
(Trim Pieces)
Use hot, soapy water and a cloth or paper towel, Dry with a clean cloth
Glass, Painted and Plastic
For general cleaning, use hot soapy water and a cloth, For more difficult soils and built-up grease,
Control Knobs, Body Parts, and
apply a liquid detergent directly onto the sell, Leave on son for 30 to 60 minutes, Rinse with a damp
Decorative Trim
cloth and dry, DO NOT use abrasive cleaners on any of these materials; they can scratch or dull the
finBh, Commercial glass cleaners recommended for glass cooktops may also be used
Control Panel
Surface Elements and Drip
Bowls
Porcelain Enamel
Cooktop
Stainless Steel, Chrome
(brushed)
Decorative Trim Cooktop
Wipe the control panel clean after each use, Before cleaning the control panel, turn all controls to
OFFand remove the control knobs To remove, pull each knob straig ht off the shaR. Clean using hot,
soapy water and a cloth Be sure to squeeze excess water from the cloth before wiping the panel;
especially when wiping around the controls, Excesswater in or around the controls may cause damage
to the applia nce, To replace knobs after deani ng, line up the flat sides of both the knob and the shaft;
then push the knob into place,
Surface elements can be unplugged and removed to make cleaning the drip bowls easier, The surface
elements clean themselves when they are turned on, Food spilled on a hot element will burn off, Food
spilled on a cool element can be cleaned with a damp cloth--any remaining soil will burn off the next
time the element is used, NEVERIMMERSE A SURFACEELEMENT IN WATER, To remove surface
elements and drip bowls, fellow the instructions under General Cleaning,
To clean drip bowls, wash in hot, soapy water or in the dishwasher, Rinse and dry while still warm,
Hard-to-remove, burned-on soils can be removed by soaking the drip bowls for about 20 minutes
in a slightly diluted liquid cleanser or a solution made of equal parts ammonia and water. A nylon
scrubber may be used after soaking, DO NOT use abrasive cleansers or steel wool, asthey will scratch
the surface, Always rinse with clean water and polish, and dry with a soft cloth or paper towel To
replace drip bowls and surface elements, follow the instructions under General Cleaning,
Gentle scouring with a soapy scouring pad will remove most spots, Rinsewith a 1:1 solution of clear
water and ammonia tfnecessary, cover difficult spots with an ammonia-soaked paper towel for 30
to 40 minutes, Rinse with clean water and a damp cloth, and then scrub with a soap-filled scouring
pad, Rinse and wipe dry with a clean cloth or paper towel Remove all cleaners or the porcelain may
become damaged during future heating, DO NOT use spray even cleaners on the ceoktop,
Cover stubborn spots with an ammonia-soaked paper towel for 30 to 40 minutes Rinse with clean
water and a cloth A soapy, nylon mesh scouring pad may be used carefully on stainless steel; not
on chrome Cleaners made especially for stainless steel, chrome or copper are also recommended,
Do net use metal-type scouring pads on brushed chrome This could cause the brushed chrome to
change to a yellowish tint, Rinse all cleaners before operating cooktop, Bluish stains may result due
to heat combining with the cleaning material and they cannot be removed,
Ceramic -Glass
SeeCeramic-Glass Cooktop
in this Owner's Guide,
Ceoktop
12

Advertisement

Table of Contents
loading

Table of Contents