Selecting Surface Cooking Utensils; Specialty Pans& Trivets - Frigidaire FEC30C4ABA Owner's Manual

Selecting Surface Cooking Utensils
For best results and energy conservation, choose cooking utensils that have these characteristics:
Pans should have flat bottoms that make
good contact with the entire surface ele-
ment Check for flatness by rotating a ruler
across the bottom There should be no
gaps between the pan and ruler,
Note: Always use a utensil for its intended
purpose, Follow manufacturer's instruc-
tions, Some utensils were net made to be
used in the oven or on the ceoktop,
*GOOD
1
u
t t
• Flat bottom and straight sides,
• Tight fitting lids.
• Weight of handle does not tilt pan, Pan
is well balanced,
• Pansizesmatch the amount of food to
be prepared and the sizeof the surface
element
• Made of material that conducts heat
well,
• Easy to clean
Specialty pans such as lobster pots, griddles
and pressure cookers may be used but must
conform to the above recommended cook-
POOR
Curved and warped pan bottoms,
u
Pan overhangs unit by more than 25
cm(1 "),
1
.... ,+
I+iiiiiiiiiiiiiiiiiii iiiiilli!!!!F u
m
Heavy handle tilts pan,
Pan is smaller than element
Iiiiiiiiiiiiiiiiiiil _11
ware requirements,
Specialty Pans & Trivets
Woks with flat bottoms suitable for
use on your cooktop are available in
most cookshop or hardware stores,
Round-bottomed woks (with a support
ring that does not extend beyond the
heating element) may also be used,
The metal ring was designed to
support the wok safely when it isfilled
with large amounts of liquids (soup
making) or fat (frying),
DO NOT use two
elements (if the cooktop is not
equipped with bridge element) to heat
one large pan such as a roaster or
griddle, or allow cooking utensils to
boil dry, The bottom surface of the
pan in either of these situations could
cause discoloring or crazing of the
porcelain enamel range surface, and
damage to the surface elements and/
or damage to the drip pans (if
equipped).
Wire trivets: Do not use wire trivets.
Cookware bottoms must be in direct
contact with the surface elements.
DO NOT use a wok if it is equipped with
a metal ring that extends beyond the
surface element, Because this ring traps
heat, the surface element and cooktop
surface could be damaged.
For glass smoothtop models, only flat
bottomed woks (without support rings)
may be used,