Frigidaire LGHN2844MP5 Use & Care Manual page 9

Getting through narrow spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the
toe grille (see "Installation" section).
3 Remove any food from the door shelves
and close the doors.
To remove the top hinge covers:
1 Remove the two (2) screws from each
cover over the top door hinges.
2 Lift inside edge of hinge cover and tilt
back.
DO NOT remove the ground screw from
hinge.
To remove the refrigerator doors:
1 Trace lightly around the door's top hinges
with a pencil. This makes reinstallation
easier.
Front
cover screw e ..... Rear
\ A _-- cover
Top hinge _J _ screw
cover
Hinge "h-_-_/- Ground
screws _--
Multi-wire
hinge
Disconnect the harness by grasping both
sides of the connector firmly, depress the
latch, and pull apart. Remove the two (2)
screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
Leave
hin J
door
Rear Front
Cover ---_ Cover Screw
Screw-_/l__ / Top Hinge
I
To_ Hinge
u,_'_ Screw _Screws
Two Wire
' II
Leave
With
_t ooor
_!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! ¸ii ¸ilii