Advertisement
Dr yirg
ocedur
• Follow the guidelines below for preparing the load for drying.
• Read the q:ezmtlrrj _structicns
card for operating your specific model.
• Alwaysread and follo_fabriccare labelsand laundryproNm_ labels.
Follow fabric care label instructions.
Place small items in a mesh bag.
Fill dryer drum 1/3 to 1/2 full•
[I _i'A'/:_lt_ll#[_'l T o reduce the risk of fire, electrical shock, or injury to persons, read
_poztant
Safety Znst:_ct±cms, pages 2-3, before operating this dryer.
1
Prepare
items for dryir_.
•
Dry items of similar fabric, weight and construction in the same load.
•
Separate dark items from light-colored items. Separate items that shed lint
from those that attract lint. If an item sheds lint, turn it inside out,
•
Besure buckles, buttons and trim are heatproofand won't damagethe drum
finish. Close zippers, fasten hooksand Velcro®-like fasteners. Tiestringsand
sashesto prevent snagging and tangling.
•
If possible, turn pockets inside out for even drying,
•
Check for stains which may not have been removed in washing, Dryer heat
may permanently set some stains. Repeat stain removal process before
drying.
•
Placesmall items in a mesh bag to prevent tangling and for easy removal.
Z
<hack that
lint screenis
clean and in
place.
A
5
Lcad the dr_r.
The average load will fill the drum 1/3 to 1/2 full. Items need room totumble
freely for even drying and less wrinkling. Do not overload dryer.
When drying large items, dry only 2 or 3 at a time, Filloutthe load with small
and medium sized items.
Fordelicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets.
Do not overdry items, Overdrying can cause wrinkling, shrinkage, harshness,
and a build-up of static electricity, which can produce more lint,
If desired, add a dryer fabric softener sheet.
Close the dryer chor and set dryer ccntrols (some models).
See Operating
Instructions card for your specific model controls.
T_m cycle selectcrclcckwiseto the desiredsetting.
6
PushStart Button for 2 seconds or turn the STARTknob clockwise to O N, hold
for 1-2 seconds and release.
To add or remove items when the dryer isrunning, open the door, The dryer
will always stop when the door is opened, Allow the drum to come to a
complete stop before reaching inside,
To restart dryer, close the door then push the Start Button for 2 seconds or
turn the STARTknob clockwise to ON, hold for 1-2 seconds and release.
The dryer will not start if the cycle selector is in the OFF position,
7. When the cycle ends, remove
items
imrediately
and hang
ac fold.
If load is removed before the cycle ends, turn cycle selector to OFF.
4
Advertisement
