Advertisement
Available languages
Available languages
[] Channel
Selection
Selectchannelsby using [CN A/V]
or [the Number buttons].
. To select the memorized
channels,
use [CH AIr]
or
[the Number
buttons].
. To select the non-memorized
channels,
use
[the Number
buttons].
To Use [the Number buttons]
- When selecting
channel
11
- When selecting
digital
channel
1I-I
Be sure to press [-]
before entering
the subchannel
number.
[] Volume
Adjustment
Thissection describeshow to adjust the volume. T hemute function, which
turns the sound off andon, isalso described.
Use [VOL _ I_]
to adjust the audio volume.
The volume
bar will be displayed
at the bottom
of the
TV screen when adjusting
the volume.
. The volume
bar will automatically
disappear
in a few
seconds.
Press ]MUTE _<] to turn offand
on the sound.
MUTE
. Press [CH RETURN] to return to the previously
channel.
About
digital
111 broadcasting:
With its high definition
broadcast,
digital
broadcasting
far surpasses analog broadcasting
in both its picture
and sound quality.
Not all digital TV broadcasts
are high
definition
(HD). To confirm
whether
your watching
TV
program
is in HD, refer to the program
guide, contact
your cable / satellite provider
or local TV stations.
NTSC
II_
ATSC
(analog mode)
(digital mode)
6:oopm
7:oop_
7:3opm
What is the subchannel?
By using high compression
technology,
digital
broadcasting
offers a service that enables
multiple
signals to send simultaneously.
Therefore,
you can select more than one program
per
main channel
since digital
broadcasting
technology
distinguishes
between
multiple
channels
broadcast
by
a single network.
Note:
• "No Signal'willappearon
the TVscreen after the
subchannel broadcast is over.
• "Audio onlyprogram" message will appear on the TV
screen, when you receiveonly sound signal
"Mute"
is displayed
on the TV screen for a few seconds.
Press [MUTE D_:] again or [VOL _/_]
to recover the
original
volume.
[] SleepTimer
Thesleeptimer can beset to automatically turn off the unit after an
incremental p eriod of time.
_
Press [SLEEP] to setthe
sleep timer.
Sleep timer display appears on the TV screen.
_
Press [SLEEP] repeatedly
to change
the amount
of time
until shut off.
You can set your unit to turn off after a set period of
time (from 30 to 120 minutes).
, Each press of [SLEEP] will increase the time by 30
minutes.
, After setup, the sleep timer display can be called up
for checking
by pressing [SLEEP].
To cancel the sleep timer
Press [SLEEP] repeatedly
until "Sleep Off" is displayed
on the TV screen.
Note:
• The sleep timer display
will automatically
disappear
in a
few seconds.
• Whenyoudisconnecttheunitfrom
theACoutletorwhen
a power failure occurs, the sleep timer setting
will be
canceled.
EN
Advertisement
