Advertisement
Available languages
Available languages
Before you connect,,,
Be sure your antenna or other device is connected properly before plugging in the ACpower cord.
[] Antenna
Connection
Connect
the RF coaxial cable on your home outlet to the antenna
input jack of this unit.
e.g.)
VHF/_
antenna
g
@
rear of this unit
RF coaxial cable
cableTV signal
* Once connections
are completed,
turn on the unit and begin initial setup. Channel scanning
is necessary for the unit
to memorize
all available
channels
in your area. (Refer to"lnitial
Setup" on page 13.)
Note:
• If you have any question
about the DTV's antenna,
visit www.antennaweb.org
for further
information.
• Depending
on your antenna
system, you may need different
types of combiners
(mixers) or separators
(splitters).
Contact your local
electronics
store for these items.
• For your safety and to avoid damage
to this unit, please unplug the RF coaxial cable from the antenna
input jack before moving
the unit.
• If you use an antenna
to receive analog
TV, it should also work for DTV reception.
Outdoor
or attic antennas
will be more effective than
settop versions.
. To switch your reception
source easily between
antenna
and cable, install an antenna
selector.
. Ifyou connect to the cable system directly, contact
the CATVinstaller.
[] Connection
to Cable
Receiver
or Satellite
Box
Use an HDMI or an RCA component
video cable to connect the HDMI or the component
video input jack of the unit to the
HDMI or the component
video output jack of the cable receiver/satellite
box.
If you connect
to the unit's component
Video Input jack, connect
RCA audio cables to the Audio L/R jacks below the
Component
Video connector.
e.g.)
HDMI cable
satellite
dish
side or rear of this unit
cableTVsignal iiiiiiiiiiiiiiiiiiiiii
........................................
including PPV
cable receiver / satellite
box
RCAcomponent video cable
and RCAaudio cable
* You can also connect
this unit to the cable receiver or satellite box other than the HDMI or the component
video
output
jack because they might
have different
output
jacks.
* Required
cables and connecting
methods
of the cable receiver / satellite
box, or the availability
channel
for the
clear QAM may differ depending
on the cable / satellite
provider.
For more information,
please contact
your cable /
satellite
provider.
EN
Advertisement
