Installation - Electrolux EI26SS30JS3 Use & Care Manual

Instal ion
This Use & Care Guide provides general operating
instructions for your model. Use the refrigerator
only as instructed in this Use & Care Guide. Before
starting the refrigerator, follow these important
first steps.
Location
= Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
If possible, place the refrigerator out of
direct sunlight and away from the range,
dishwasher or other heat sources.
The refrigerator must be installed on a floor
that is level and strong enough to support a
fully loaded refrigerator.
Consider water supply availability for models
equipped with an automatic ice maker.
Toe Grille Installation and Removal
To install toe grille
1 Open both doors. Slide left and right sides of
toe grille over lower hinges of refrigerator.
2 While pushing toe grille firmly against
cabinet, fasten bottom clips of toe grille to
cabinet.
3
4
Fasten top clips to cabinet.
Close the doors. On the left and right sides,
pull out and up on the toe grille until the
triangle tab is resting on the top edge of the
hinge. The edge clip should snap into the
hinge pocket on the back edge of the hinge.
Installation
Installation clearances
Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides & Top ¾ inch
Back 1 inch
To remove toe grille
1 With both doors closed, unfasten right and
left side clips of toe grille from bottom hinge
groove.
2 Open both doors. Press firmly on top of toe
grille until top of toe grille pops off.
3 Pull toe grille outward towards your body and
off of lower hinges.