Electrolux EI26SS30JS3 Use & Care Manual page 37

Solutions To Common Problems
TemperaturesAre TooWarm
Problem
Freezer/
Refrigerator
temperature is too
warm.
Freezer
temperature is too
warm. Refrigerator
temperature is
satisfactory.
Refrigerator
temperature is
too warm. Freezer
temperature is
satisfactory.
Temperature in
the Meat Keeper
is too warm (some
models).
Cause
* Doors are opened too
frequently or too long.
o Door is slightly open.
Correction
Warm air enters the refrigerator whenever the door is
opened. Open the door less often.
See Problem section, Opening/Closing of Doors/Drawers.
Freezer control is set too
warm.
Set freezer control to a colder setting. Allow 24 hours for
temperature to stabilize.
Refrigerator control is set
too warm.
Set refrigerator control to a colder setting. Allow 24 hours
for temperature to stabilize.
Meat Keeper temperature
control is set too warm.
Adjust Meat Keeper temperature control to a colder
setting.
Water/Moisture/Frost Inside RefrLqerator
Problem
Moisture collects on
inside of refrigerator
walls.
Water collects on
bottom side of
drawer cover.
Moisture collects in
bottom of drawer.
®
Moisture collects on
outside of refrigerator
or between doors.
Cause
• Weather is hot and humid.
Door is slightly open.
Door is opened too often or
too long.
Open containers.
Vegetables contain and give
off moisture.
Correction
The rate of frost buildup and internal sweating increases.
See Problem section, Opening/Closing of Doors/Drawers.
Open door less often to allow internaltemperature to stabilize.
Keep containers covered.
Moisture on the bottom side of the cover is not unusual.
Move humidity control (some models) to lower setting.
Washedvegetables and fruit
drain while in the drawer.
Fruits and vegetables are kept
_rime
Weather is humid.
Door is slightly open,
causing cold air from inside
refrigerator to meet warm air
from outside.
Dry items before putting them in the drawer. Water collecting in
bottom of drawer is normal.
Routinely clean out old fruits and vegetables especially if they
beqin to break down.
This is normal in humid weather. When humidity is lower, the
moisture should disappear.
See Problem section, Opening/Closing of Doors/Drawers.
Perfect TempDrawer (some models)
Problem Cause Correction
Display does not • Connector not connected or • Remove pan and insure connector is fully engaged. (See Storage
illuminate or shows loose. Featuressection)
"CE".
Display shows "LOC" • Drawer in control lock mode. • Press and hold control lock button for three seconds to take
when buttons are drawer out of control lock mode. (See Storage Featuressection)
pressed.