Cycle Takes A Long Time; Dishwasher Has An Odor; Removing Spots And Film - Electrolux EDW7505HSS0A Use & Care Manual

Solutions to Common Problems 21
DISHWASHER HAS AN ODOR ERROR CODES
Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.
There will be a "new" smell when first
installed. This is normal.
Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
20).
REMOVING SPOTS AND
FiLM
Hard water can cause lime deposit build-up on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
19).
To remove build-up, spots and film, clean
using the following instructions:
1 Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2
3
Do not add detergent.
Select the NORMAL WASH cycle. Press
START/CANCEL pad and close door.
Allow dishwasher to run until it begins the
second fill. Open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
Close and latch door and allow cycle to
finish.
NOTE
If these conditions persist, a home water
softener should be considered.
In certain situations which are critical to the
machines function and safe operations.
Er01
Leak Detector - When water is detected under
the tub.
Er02
Thermistor- When thermistor/turbidity module
fails
Er03
Wash Pump - Wash pump not operating
Er04
Drying Damper - Drying damper not operating
Er05
Upper Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the upper fan
Er06
Lower Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the lower fan
Er 07
Drain Valve - When in the drain mode, the control
board does not receive proper position feedback
from the drain valve
Er08
Tactile or touch switch - Control board has
verified a switch on the user interface is bad or
shorted
Er09
Communications - Communication failure be-
tween main user board and power supply
Erl0
Mains Relay - Failure in the mains power relay
Er11
Drain Valve - Time out before finding a state for
the drain valve
Er12
Drain Valve - The drain valve is running when it
should be off
Er13
System wide - Lost control of the State Machine