Table of Contents
Advertisement
Oven Controls
SABBATHFEATURE
(CONT)NUED)
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
+ key pad will
Note: You may change the oven temperature once baking has started. The HI hi
increase the temperature by 5°F (2°C) at each key press. The LO io key pad will decrease the
temperature by 5°F (2°C) at each key press. Remember that the oven control will no longer
beep or display any further changes once the oven is set for the Sabbath feature.
8. The oven may be turned OFF at any time by pressing CANCEL @ pad (this will turn the
+
oven OFF only). To turn OFF the Sabbath
feature press and hold both the HI hi and LO Io pads
for at least 3 seconds. SAb will disappear from the display.
Should you experience a power failure or interruption, the oven will shut off. When power is
returned the oven will not turn back on automatically. SF (Sabbath Failure)will be displayed in
the oven control display and the surface element displays. The oven will remember that it is set
for the Sabbath and the food may be safely removed from the oven while still in the Sabbath
feature, however the oven cannot be turned back on until after the Sabbath. After the Sabbath
+ and LO io pads for at
observance turn OFF the Sabbath feature. Press and hold both the HI hi
least 3 seconds. SAb will disappear from the display and the oven may be used with all normal
functions. For further assistance, guidelines for proper usage, and a complete list of models with
the Sabbath feature, please visit the web at http:\\www.star=k.org.
Notes for the use of the cooktop
in Sabbath mode:
• When the Sabbath feature is enabled on the oven control, it is also enabled on the cooktop.
To activate the Sabbath feature, it is not necessary to have one burner ON, but it is necessary
to have a Bake function active in the oven.
• When the Sabbath feature is enabled, a surface element can be turned ON by pressing the
ON/OFF pad. The elementwil( turn ON 15 to 30 seconds after the ON/OFF pad was pressed.
Once a surface element is on, its display shows "Sb".
• When the Sabbath feature is enabled, the power level of an active element can be changed.
The change will take effect after a 15 to 30 seconds delay. The element size (inner/outer)
CANNOT be changed.
Hide quick links:
Advertisement
Table of Contents
