Advertisement
1
Make certain the unit is not plugged
into an electrical
outlet.
2
Carefully
push the power cord grommet
through
the hole
in the back panel. See Figure
2.
3
Remove
12 screws
and back panel.
4
Check that the clamps
and hose connections
are tight at
the following
areas illustrated
in Figure
3:
Discharge
tube (A)
,, Drain tube (B)
,, Vent tube (C)
5
Place a suitable
container
beneath
the pump's
discharge
tube. (Container
must be able to hold a
minimum
of one gallon of water.)
BACK VIEW
Figure 3
GROMMET
Figure 2
SDE ViEW
UL184_2
BACK
PANEL
DRAIN
FiTTiNG
POWER
CORD
UL184=1
Plug the ice maker power cord into a properly
grounded,
polarized
electrical
outlet.
Verify pump operation
by pouring one gallon of water into the ice storage
bin
of the ice maker. The pump should
energize
and pump the water into the
container.
8
At this time, verify that all tube and clamp connections
are tight and leak free.
9
Unplug
unit power cord from electrical
outlet.
10
Reinstall
back panel.
11
Continue
to the next step in the installation
process,
Site Preparation.
Advertisement
