Partsand Features; Ught Bulb Changing - Kenmore Power-Mate 1162561190 Owner's Manual

= TM
. OWER MATE CARE
Always foIIow all safety precautions when cleaning
and servlclng the POWER-MATE
TM,
WARNING
Elecl#cal Shock Or Persona}injury Hazard
Disconnect electrical supply before servicing or
cleanlng lhe unlL Failure to do so could result in
electrical shock or personal injury from cleaner
suddenly starting,
........................ i i i i i i
UGHT BULB CHANGING
1, Remove iight
cover by pressing in
and ilffing both sides
as shown.
2_PushIn and turn
bulb counterclock-
wise to remove
3. Replace the butb.
Bulb must not be
htgher than 15
Wafts Close light
cover until It snaps in
place
NOTE: See PARTSAND FEATURES for Bulb #
_ELT CHANGINGAND BRUSH CLEANING
Disconnect cleaner from electrical oullet. Check
and remove hair, s tring and tint b ulld-up frequently
inthe POWER-MATE
TM
b_ush and brush support areas_
If build-up becomes excessive, dtsconneci POWER-
MATE
TM
fFom wand and follow the steps below,,
Instructions can also be found under the light cover
TO REMOVEBEE:
__ , ,, ,
!I ,
1. Remove ilght cover
and light bulb as
shown under UGHT
BULB CHANGING
2, Unscrew the
POWER_MATE
TM
cover
screws.
3, Turn POWER-
MATE
TM
over. To
remove cover.
Insert screw-
driver of cover
tabs on both
sides and twist
to release tabs
4. Turn POWER-
MATE
TM
right side
up Press handle
release pedal
and lower the
swivel. TiIf cover
forward from
back until front
snaps free.
14