Table of Contents
Advertisement
General Care & Cleaning
Removing
and Replacing
Warmer (Warm & Ready
TM)
Drawer
To Remove Warmer Drawer:
1.
_
Turn power off before removing the warmer drawer.
2.
Open the drawer to the fully opened position.
3.
Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever (see figure 1).
5.
Pull the drawer away from the range.
To Replace Warmer (Warm & Ready
TM)
Drawer:
1.
Pull the bearing glides to the front of the chassis glide (see figure 2).
2.
Align the glide on each side of the drawer with the glide slots on the range.
3.
Push the drawer into the range until levers "click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click"
or the bearing glides do not feel seated remove
the drawer and repeat steps 1 thru 3. This will minimize possible damage
to the bearing glides.
Figure 1
Figure 2
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
Oven
Light
Wire
Holder
Changing
the Oven Light
The oven light automatically turns on when the door is opened. The oven light is
located at the rear of the oven and is covered with a glass shield held by a wire
holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light:
1.
Turn electrical power off at the main source or unplug the range.
2.
Press wire holder to one side to release the glass shield.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug the range back in).
6.
The clock will then need to be reset. To reset, see Setting the Clock and
Minute Timer in this Use & Care Guide.
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Wear a leather-faced glove for protection against possible
broken glass.
Care and Cleaning
of Stainless
Steel
(some models)
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required
for maintaining the
appearance of stainless parts. Refer to the Care & Cleaning table for detailed cleaning instructions.
28
Advertisement
Table of Contents
