Advertisement
Washing
Procedures,
continued
, To select or delete an option, press OPTIONS; then,
while the indicator is blinking, press Select. The indica-
tor will light when the option has been selected. It will
no longer be lighted when the option has been deleted.
To provide the best care for your laundry, not every
setting or option is available with every cycle. If a setting or
option is not available for the cycle selected, the indicator will
not light.
• Adjustments to a cycle will be remembered and re-
called each time that cycle is selected in the future.
• To return to factory settings, press the Pause/Cancel
and Select buttons at the same time and hold until the
signal sounds.
' _i_em d
0 High
0 Cokl/€old
0 M(_d
OWa
m/Co_d
O Low
O
0 Wa_m/Wa m 0 Ha[_gDw
0 i
0
0 }[O /COld
0 NOS}} n
0 S
0
csa
< _7
Pressand hold both for ten seconds
to return to factory settings.
Start the washer.
• Close the door and press STARK The washer will not
operate with the door open. "PRU"
will be displayed
as a reminder to close the door.
If desired, select Delay Start to delay the beginning of
the cycle for up to 12 hours. The delay time selected
will be displayed as 30, 60 or 90 minutes or 2 through
12 hours.
As a safety measure, the door will automatically lock
during the entire wash cycle and the DoorLock
indica-
tor will be lighted.
A forgotten item can be added to the wash drum.
PressPause/Cancel once. "PRU"
will be displayed
alternately with the estimated cycle time. Open the
door, add the item, close the door and press STARTto
resume the cycle.
If changes to the settings or options are attempted
after the cycle starts, you will hear several beeps when
the buttons are pressed. To change the settings or op-
tions, press Pause/Cancel twice, make the new selec-
tions and press Start again.
To change the cycle once the cycle has begun, press
Pause/Cancel twice, select a new cycle, and press
Start again. Just turning the cycle selector knob will
not change the cycle.
To stop the cycle, press Pause/Cancel twice.
If the cycle is interrupted during spin, it will take ap-
proximately 2-3 minutes for the door lock to release. DO NOT
force open the door.
o
o
A signal will sound at the end of the cycle if the Cycle
Signal option has been selected.
Remove items from the washer when the cycle ends
and place in dryer, line dry or dry flat as directed on the
fabric care label.
_
or best results
Follow the fabric care label instructions
on items to be washed.
Excesswrinkling, color transfer or odors may develop
in items left in the washer after the cycle has ended, if
not removed promptly.
- ENTRAPMENT and TIP-OVER HAZARD -
Do not leave the door open if there are small children or pets
present. An open door could entice children to hang on the
door or crawl inside the washer. If there are no small children
present, you may leave the door ajar to prevent odor build up.
Advertisement
