Bosch SHV99A13UC Use And Care Manual page 12

Operating the Dishwasher (ooot o o¢
End Signam
The dishwasher emits a tone (five times) to let
you know that your dishes are clean and dry. You
can change the tone volume or you can disable
it.
NOTE: In the Options Step Down Menu you can
return to the main menu at any time by pressing
the START button.
1. Open the dishwasher door far enough to
expose the control panel.
2. Press the ON/OFF button.
3. Press the MENU/OK button four times to
display the current End Signal setting
4. Press the ÷ or - buttons to obtain the
desired volume.
End Signal 6 -loudest setting (factory
default setting)
End Signal 0- End Signal disabled
5. After selecting the desired volume, you must
press the MENU/OK button to save the
setting. The display will show "Value Stored"
and return to the main menu. tf you did not
change the volume, press the START button
to return to the main menu.
6. Select the desired wash cycle by pressing
the - or ÷ buttons.
7. Press START and close the dishwasher door
to begin the cycle.
Rinse Agent Adjustment
This option allows you to adjust the amount of
rinse agent the dishwasher will dispense to
control spotting or streaking.
NOTE: In the Options Step Down Menu you can
return to the main menu at any time by pressing
the START button.
1. Open the dishwasher door far enough to
expose the control panel.
2. Press the ON/OFF button.
3. Press the MENU/OK button five times to
display the current rinse agent setting.
4. Press the + or - buttons to display the
desired amount of rinse agent.
5. tf your glassware is spotted, press + to
increase the amount of rinse agent
dispensed. If your glassware is streaked,
press - to decrease the amount of rinse
agent dispensed.
Rinse Agent 6 - maximum amount of
rinse agent available
Rinse Agent 4 - factory default setting
Rinse Agent 0 - rinse agent dispenser
disabled
.
After selecting the desired amount of rinse
agent to be dispensed, you must press the
MENU/OK button to save the setting. The
display will show "Value Stored" and return to
the main menu. If you did not change the
rinse agent amount, press the START button
to return to the main menu.
7. Select the desired wash cycle by pressing
the - or ÷ buttons.
8. Press the START button and close the
dishwasher door to begin the cycle.
Display Language Selection
This option allows you to select the display
language. The first time that you use your
dishwasher this screen will automatically appear.
NOTE: In the Options Step Down Menu you can
return to the main menu at any time by pressing
the START button.
.
2.
3.
4.
.
6.
.
8.
Open the dishwasher door far enough to
expose the control panel.
Press the ON/OFF button.
Press the MENU/OK button six times to
display the current language setting
The available language choices are:
AE = American English
CF = Canadian French
MS = Mexican Spanish
Press the ÷ or - buttons until the desired
language flashes.
After changing the language selection, you
must press the MENU/OK button to save the
setting. The display will show "Value Stored"
and return to the main menu. If you did not
change the language, press the START
button to return to the main menu.
Select the desired wash cycle by pressing
the - or ÷ buttons.
Press START and close the dishwasher door
to begin the cycle.
11