Control Pad Functions; Setting The Clock - Kenmore 790.9010 Series Use & Care Manual

Control Pad Functions
Note: The appearance of your oven control may differ slightly from the one illustrated below. However, all functions are
the same.
READ ALL INSTRUCTIONS CAREFULLY BEFORE USINGTHE OVEN. Detailed instructions for each function follow later
in this book. For satisfactory use of your oven, become familiar with the various functions of the oven as described below.
O FF/CANCEL
Used to clear any
oven mode previously
entered except the
time of day and the
minute timer. Push
clear to stop cooking
UP and DOWN ARROWS
Used to set the clock, the
timer
CLOCK
Used to set the
time of the day.
CLO
°Q°
BAKE
Used to enter the
normal baking mode
BROIL
Used to select the
broil mode
- OOK TiME
Used to enter
the length of the
cooking time.
CLEAN
Used to select the
self-cleaning
mode
OVEN, PREHEAT
ANDLOCKED
Indicateswhich
modeisinuse.
TIMER
Used to set or cancel
the minute timer. The
minute timer does not
start or stop cooking.
Note: Push buttons or pads may be shaped differently.
STOP TIME-
Used with BAKE, OVEN COOK
TIME, and CLEAN to program
delayed baking or delayed self-
cleaning cycle stop time.
iii .........
..... iH .....
Note:
After the appliance is first plugged in, or after a power interruption, the clock must be set
to the correct time of day before the rest of the electronic control functions will operate.
The oven can be
programmed
for:
• Conventional baking and roasting
• Conventional Timed baking and roasting with automatic on and off times.
• Vari broiling
• Self-cleaning
For a silent control panel:
When choosing a function, a beep will be heard each time a pad is pushed. If desired, the controls can be programmed for
silent operation. Push and hold STOP TIME. After 7 seconds, the control will beep once. This will block the controls from
sounding when a pad is pushed. To return the sound, push and hold STOP TIME again for7 seconds until a beep is heard.
Note: The control will return to the audible mode after a power outage.
Setting the Clock
When the range is first plugged in, or when the power supply to the range has been interrupted, the display will flash
"12:00".
INSTRUCTIONS
To Set the Clock: (example 1:30)
1. Push _.The timer allows you 5 seconds to go to step 2.
2. Push and hold the/_ or v to set the time of day to
1:30. You may also push _.
Note: The time cannot be changed during any timed bake or self-clean cycle.
PRESS DISPLAY
Aorv
®
13