Advertisement
_'_
Installing
Cooking
Components
Important: Before cooking on your grill the first
time, wash the Cooking Grids with warm, soapy
water. Rinse and dry thoroughly. Season with
cooking oil regularly. After cooking is completed,
turn grill to HIGH setting for about five minutes to
burn off excess grease or food residue.
1.
Place the 3 Steel Flame Tamers on the lower
ledge above Burners.
2.
Evenly space the Cooking Grids on the ledge
above the Flame Tamers.
SECONDARY
COOKING
RACK
COOKING
GRID
STEEL FLAME
TAMER
SLOTS FOR
RACK
3.
Place the Secondary
Cooking Rack into the
slots on the upper left and upper right of Grill
Bowl Panels.
Connecting
A Liquid Propane Gas
(LP gas) Tank To Your Grill
1.
Open the front Doors of cabinet.
Place a 20
lb tank with foot ring into the hole in the
Bottom Shelf. Make sure the tank valve is in
the OFF positon. (Turn clockwise
to close.)
Align the tank so the Tank Valve faces the
rear right corner of cabinet. Use provided Wing
Bolt to secure gas tank. See W
2.
.
4.
5.
Wing Bolt 1/4"x4-3/8"
Qty. 1
Ref. # $233G04382
Check the tank valve to ensure it has proper
external
mating threads to fit the hose &
regulator assembly provided. (Type 1 connec-
tion per ANSI Z21.58b-2002)
Be sure all Burner Valves are in the OFF
position.
Inspect the valve connection
port and regulator
assembly.
Look for damage or debris. Remove
any debris. Inspect hose for damage. Never
use damaged or plugged equipment.
When connecting
the regulator
assembly to
the tank valve, hand..._._hten nut clockwise
to
a full stop. See
_L_
DO NOT use a
wrench to tighten because it could damage
the Quick Coupling
Nut and result in a
hazardous condition.
.
1.
2.
Open the tank valve fully (counterclockwise).
Use a soapy water solution to check all
connections
for leaks before attempting
to light
your grill. See "Checking
for LP Gas Leaks"
on page 19. If a leak is found, turn the tank
valve off and do not use your grill until the
leak is repaired.
Disconnecting
A Liquid Propane Gas
(LP gas) Tank From Your Grill
Turn the Burner Valves and LP gas tank valve
to the full OFF position.
(Turn clockwise to
close.)
Detach the hose and regulator
assembly from
the LP gas tank valve by turning the Quick
Coupling Nut counterclockwise.
\
Right Cart Side Panel Hole for Regulator to
connect Gas Tank Valve
Type I connection
per ANSI Z21.58b-2002
QUICK j
COUPLING
NUT
CAUTION: When the appliance
is not in use, the
gas must be turned off at the supply tank.
18
Congratulations
Your Kenmore
LP gas grill is now ready for
use. Before the first use and at the beginning
of each season (and whenever the LP gas
tank has been changed):
1. Read all safety, lighting and operating
instructions.
2.
Check Gas Valve Orifices, Burner Tubes
and Burner Ports for any obstructions.
3.
Perform gas leak check according
to
instructions
found on page 19 of this
manual.
Advertisement
