Control Panel - Amana 8113P554-60 Use & Care Manual

¢ookln______jg
Control Panel
A B C D G H
\\
I J K L M
The control panel isdesigned for ease in programming. The displaywindow on the control shows time of day, timer and oven functions.
Control panel shown includesmodel specific features. (Styling may vary depending on model.)
iiFiiiiiiiiiiiiiii!
ii|!i!i!i!i!i!ii!!i!i!i_i!
iJiiiii!!ili;!!iiiii:i
iiEii!!!
Convect
(select models)
Bake
Broil
Cancel
Clock
Oven Light
Favorite
Clean
Cook & Hold
Keep Warm
Delay
Number Pads
Autoset
Timer
Use for convection baking and
roasting.
Use for baking and roasting.
Use for broiling and top browning.
Cancels all operations except Timer
and Clock.
Use to set time-of-day clock.
Use to turn the oven light on or off.
Use to set and save a specific Cook &
Hold procedure.
Use to set self-clean cycle.
Bakes for a preset time, then holds
food warm for 1 hour.
Use to keep cooked food warm in oven.
Programs the oven to start baking at
a later time.
Use to set time and temperature.
Use to quickly set temperatures.
Sets Timer.
Using the Touchpads
Press the desired pad.
Press the number pads to enter time or temperature.
Press the Autoset 0 pad to enter temperature.
• A beep will sound when any pad is touched.
• A double beep will sound if a programming error occurs.
Note: Four seconds after pressing the number pads
or the Autoset 0 pad, the time or temperature will
automatically be entered. If more than 30 seconds elapse
between touching a function pad and the number pads or
the Autoset O pad, the function will be canceled and the
display will return to the previous display.
Clock
The clock can be set to display time in a 12-hour or 24-1/our
format. The clock is set at the factory for the 12-hour format.
To change the clock to
24=hour format:
1. Press and hold the Cancel and
Favorite pads for three seconds.
• 12 Hr flashes in the display.
Press the Autoset O pad to select 24
Hr; press again to select 12 Hr.
Set the time of day following the directions
in the "To set the Clock" section.
To set the Clock:
1. Press the Clock pad.
• The time of day flashes in the display.
2. Press the appropriate number pads to set the time of day.
• Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
• The colon will remain on.
When electrical power is supplied or after a power
interruption, the last clock time before power was interrupted
will flash.
cont.